Skip to content

Chimney Liner Installation in Park Slope, Brooklyn

Serving Park Slope and nearby cities. Tell us about the job and we’ll call you back to confirm the details.

Tell us what’s going on

Prefer to talk? (361) 329-4790

The short answer

A chimney liner is the protective channel inside a masonry chimney that carries exhaust safely out of the home. Many older Park Slope chimneys have cracked or missing liners, and a new liner is often needed when a building's boiler is converted from oil to gas. NorthStar inspects the flue first, then recommends and installs a liner sized to your appliance.

Many Park Slope homes were built long before modern furnaces, boilers and water heaters existed. The chimneys in these brownstones, rowhouses and pre-war apartment buildings often have original clay tile flues, or no liner at all, that were never designed for today's appliances. NorthStar Chimney Services installs chimney liners for homeowners and building owners in Park Slope (ZIP 11217), about a mile from our Brooklyn office. Our certified technicians inspect the flue, explain what they find, and fit a liner sized to the appliance it serves.

Why Older Park Slope Chimneys Often Need a New Liner

Most chimneys in the neighborhood serve brownstones, rowhouses and pre-war apartment buildings. Over decades of use, clay tile liners can crack, joints can open up, and mortar can wash out. Some chimneys were built with no liner, so exhaust runs directly against brick.

A damaged or missing liner can let heat reach nearby wood framing, allow carbon monoxide to leak into living space, and let acidic moisture break down the masonry from the inside. Because rowhouses often share walls, a failing flue can also affect more than one household.

  • Cracked, shifted or missing clay flue tiles
  • Crumbling mortar or brick fragments at the base of the chimney
  • Water stains, efflorescence or damp spots on interior walls near the chimney
  • A new boiler, furnace or water heater that the old flue was not sized for
  • Poor draft, smoke spillage or exhaust odors indoors

Oil-to-Gas Conversions and Chimney Liners

When a New York City building converts its boiler from oil to gas, the chimney has to be evaluated as part of the work. A new liner is often needed because gas exhaust produces acidic condensate that can corrode a masonry flue.

If your building is planning a conversion, it helps to bring in a chimney technician early. We can inspect the existing flue, confirm whether it can safely vent the new equipment, and install a properly sized liner so the conversion is not held up at the end.

Liner Options We Install

The right liner depends on the fuel, the appliance, and the size and condition of the chimney. Our technicians explain the options for your specific flue rather than recommending one approach for every home.

  • Stainless steel liners for gas, oil and wood-burning appliances, commonly used when venting a new boiler or water heater
  • Insulated liners where the flue needs extra protection or better draft
  • Liners for fireplaces being restored to working use
  • Chimney caps installed with the liner to keep out rain, debris and animals

How Liner Installation Works

The NFPA 211 standard calls for chimneys, fireplaces and vents to be inspected once a year. It describes a Level 2 inspection when the system changes, such as a new appliance or a switch of fuel, or when a home is sold. A liner job usually begins with this kind of detailed inspection, often including a camera look inside the flue.

From there, we measure the flue, match the liner size to the appliance's venting needs, and clean the chimney before installation. Once the liner is in place, we connect it, seal the top, install a cap, and check that the system drafts properly. We walk you through what was done and what to keep an eye on going forward.

Planning Around Heating Season

New York City's heat season runs from October 1 through May 31. During that period, building owners must keep apartments heated to the city's minimum temperatures. For owners of multi-unit buildings, that makes timing important. Scheduling an inspection and any liner work outside heat season gives the most flexibility. If a problem turns up mid-winter, we will talk through how to plan the work with as little disruption to heat and hot water as possible.

Serving Park Slope and Nearby Neighborhoods

Along with Park Slope, we install chimney liners in Prospect Heights, Carroll Gardens, Cobble Hill, Gowanus and Red Hook. These neighborhoods share many of the same building types, from brownstones and rowhouses to pre-war apartment buildings, and many of the same chimney problems.

More services in Park Slope

Related

What to expect

How a visit goes

  1. Look first, then recommend

    We inspect and photograph the system before suggesting any repair, so recommendations are based on what is actually there.

  2. Clear, written pricing

    You receive a written price for the agreed scope before work begins, and we do not add items without talking to you first.

  3. Clean, careful work inside your home

    We cover floors and furniture, contain soot and dust, and leave the work area clean when we finish.

FAQ

Common questions

Don’t see your question? Call (361) 329-4790 and we’ll talk it through.

How do I know if my chimney needs a new liner?

Common signs include cracked or missing flue tiles, debris at the base of the chimney, moisture stains near the chimney, and poor draft. The most reliable way to know is an inspection that looks inside the flue.

Do I need a new liner if my building is switching from oil to gas?

Often, yes. In New York City the chimney has to be evaluated when a boiler is converted from oil to gas. Gas exhaust produces acidic condensate that can corrode a masonry flue, so a new liner is frequently required.

How often should my chimney be inspected?

The NFPA 211 standard calls for chimneys, fireplaces and vents to be inspected once a year. A more detailed inspection is recommended when you change appliances or fuels, or when a home is sold.

Can a liner be installed in a rowhouse with shared walls?

Yes. Liners are installed from inside the existing chimney, so the work is usually done without opening walls. Our technicians check the flue first and let you know if any other access is needed.

Will installing a liner interrupt my heat?

The appliance connected to the chimney is typically shut off while the liner is installed and connected. We will explain the expected downtime ahead of time so you can plan, especially during heat season.

Do you install liners for fireplaces as well as boilers?

Yes. We install liners for gas, oil and wood-burning appliances, including fireplaces being returned to use, and size each liner to the appliance it serves.

Schedule a Chimney or Vent Inspection

Tell us what you are noticing and where you are in Brooklyn. We will inspect, show you photos of what we find, and give you a written price before any work begins.

Call (361) 329-4790 Request Service