Skip to content

Chimney Liner Installation in Brooklyn Heights

Serving Brooklyn Heights and nearby cities. Tell us about the job and we’ll call you back to confirm the details.

Tell us what’s going on

Prefer to talk? (361) 329-4790

The short answer

Older Brooklyn Heights chimneys often have cracked, worn or missing flue linings, and buildings converting from oil to gas often need a new liner because gas exhaust produces acidic condensate that can corrode masonry. We inspect the flue, size a liner to your appliance and install it, usually from the roof.

Many homes in Brooklyn Heights were built long before modern heating equipment. Their chimneys often still rely on old clay tile or bare masonry flues. NorthStar Chimney Services installs chimney liners in brownstones, rowhouses and pre-war apartment buildings throughout the neighborhood, working from our Brooklyn office about a mile away. Our certified technicians inspect the existing flue, match the liner to the appliance that will use it, and install it so exhaust leaves the house the way it should. Here is what to know if your chimney may need a new liner.

Why Older Brooklyn Heights Chimneys Need Liners

Chimneys in brownstones and rowhouses were usually built for coal or wood fires. Over many decades, heat, moisture and flue gases wear down mortar joints and crack clay tiles, and some flues were never lined at all. A damaged flue can let heat reach nearby wood framing or let exhaust leak into living space. It can also draw poorly, so combustion gases linger instead of venting out.

Shared party walls make this especially important in attached homes. A crack in one flue can affect more than one household, and the damage is often hidden inside the masonry where you cannot see it. Watch for these signs:

  • Pieces of tile or mortar in the firebox or at the boiler cleanout
  • Water stains or peeling paint on walls near the chimney
  • White staining on the exterior brick
  • Smoke or odors in rooms while the appliance runs
  • A planned boiler or water heater replacement

Oil-to-Gas Conversions and Your Chimney

When a New York City building converts its boiler from oil to gas, the chimney has to be evaluated as part of the work. A new liner is often needed because gas exhaust produces acidic condensate that can corrode a masonry flue. Many pre-war apartment buildings and townhouses in Brooklyn Heights have already made this change or are planning it.

We coordinate with your heating contractor so the liner is sized for the new boiler or water heater. Timing matters too. New York City's heat season runs from October 1 through May 31, and during that period building owners must keep apartments heated to the city's minimum temperatures. Scheduling liner work before fall helps avoid an interruption in heat for tenants.

Choosing the Right Liner

The right liner depends on the appliance, the fuel and the shape of the flue. Common options include:

Size matters as much as material. A liner that is too large for a modern high-efficiency boiler can let exhaust cool and condense inside the flue. A liner that is too small can restrict draft. We match the liner to the appliance's venting requirements.

  • Stainless steel liners: common for gas and oil appliances and wood stoves. Flexible versions can follow the offsets found in many older chimneys.
  • Insulated stainless liners: used where clearance to combustible materials is limited or where draft needs help.
  • Cast-in-place liners: a poured lining that seals the flue and can reinforce deteriorated masonry.
  • Clay tile replacement: sometimes possible on straight runs, though it usually requires more demolition.

What Installation Looks Like

Work starts with an inspection. The NFPA 211 standard calls for a Level 2 inspection when a system changes, such as a new appliance or a switch of fuel, or when a home is sold. This usually includes a camera scan of the flue interior. If a hidden hazard has to be reached by opening part of the chimney or wall, a Level 3 inspection may be needed.

In attached homes, most liners go in from the roof. We plan roof access ahead of time and protect the rooms near the fireplace or boiler. We clean the flue, install the liner and its connections, and add a cap where appropriate. Once the appliance is running, we check the draft. You get a written description of the work we did.

Serving Brooklyn Heights and Nearby Neighborhoods

We install chimney liners in Brooklyn Heights and in nearby Downtown Brooklyn, DUMBO, Boerum Hill, Fort Greene and the Financial District. After installation, keep up with yearly inspections. The NFPA 211 standard calls for chimneys, fireplaces and vents to be inspected once a year, which helps confirm the liner stays in good condition.

More services in Brooklyn Heights

Related

What to expect

How a visit goes

  1. Look first, then recommend

    We inspect and photograph the system before suggesting any repair, so recommendations are based on what is actually there.

  2. Clear, written pricing

    You receive a written price for the agreed scope before work begins, and we do not add items without talking to you first.

  3. Clean, careful work inside your home

    We cover floors and furniture, contain soot and dust, and leave the work area clean when we finish.

FAQ

Common questions

Don’t see your question? Call (361) 329-4790 and we’ll talk it through.

How do I know if my chimney has a liner?

Often you can't tell from the fireplace or boiler room. A camera inspection of the flue shows whether there is a liner, what it is made of and whether it is cracked or deteriorated.

Do I need a new liner if I'm switching from oil to gas?

Often, yes. In New York City the chimney has to be evaluated during an oil-to-gas boiler conversion. Gas exhaust produces acidic condensate that can corrode a masonry flue, so a new liner is frequently required.

Can a liner be installed in a chimney with bends?

Usually. Flexible stainless steel liners can follow the offsets common in older brownstone and rowhouse chimneys. Cast-in-place liners are another option for irregular flues.

Will installation make a mess inside my home?

Most of the work happens from the roof. We cover and protect the area around the fireplace or boiler where we connect the liner and clean up when we're done.

When is the best time to schedule liner work?

Late spring and summer are ideal, especially for buildings with tenants. That avoids interrupting heat during New York City's heat season, which runs from October 1 through May 31.

How often should a lined chimney be inspected?

The NFPA 211 standard calls for chimneys, fireplaces and vents to be inspected once a year, including chimneys with new liners.

Schedule a Chimney or Vent Inspection

Tell us what you are noticing and where you are in Brooklyn. We will inspect, show you photos of what we find, and give you a written price before any work begins.

Call (361) 329-4790 Request Service